VMware VCAP-NV Design 2021 Certification 3V0-42.20 Exam Questions

What is the requirement of getting VMware Certified Advanced Professional – Network Virtualization Design 2021 (VMware VCAP-NV Design 2021) certification? It must be clear that passing 3V0-42.20 Advanced Design VMware NSX-T Data Center exam is required. To help candidates prepare 3V0-42.20 exam well and pass 3V0-42.20 test successfully, VMware 3V0-42.20 exam questions are released with the real questions and answers for all candidates. Read VMware VCAP-NV Design 2021 certification 3V0-42.20 exam questions with ITExamShop pdf file, we ensure that you can pass 3V0-42.20 Advanced Design VMware NSX-T Data Center exam.

Advanced Design VMware NSX-T Data Center 3V0-42.20 Free Questions Below

Page 1 of 1

 Loading...

1. Which is a family of solutions for data center designs that span compute, storage, networking, and management, serving as a blueprint for a customer’s Software Defined Data Center (SDDC) implementations? (Choose the best answer.)

VMware SDDC Design

VMware Validated Design

VMware POC Design

VMware Cloud Foundation

Launch demo modal

 Loading...

2. Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)

IPv6 OSPF

IPv6 static routing

IPv6 switch security

IPv6 DNS

IPv6 Distributed Firewall

IPv6 VXLAN

Launch demo modal

 Loading...

3. An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:

- Some workloads should be moved to a Cloud Provider.

- Extend network’s VLAN or VNI across sites on the same broadcast domain.

- Enable VM mobility use cases such as migration and disaster recovery without IP address changes.

- Support 1500 byte MTU between sites.

Which selection should the architect include in their design? (Choose the best answer.)

Load Balancer

Reflexive NAT

SSL VPN

L2 VPN

Launch demo modal

 Loading...

4. An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:

- There are six hosts and hardware has already been purchased.

- Customer is planning a collapsed Management/Edge/Compute cluster.

- Each host has two 10Gb NICs connected to a pair of switches.

- There should be no single point of failure in any proposed design.

Which virtual switch design should the architect recommend to the organization? (Choose the best answer.)

Create a vSphere Distributed Switch (vDS) for Management VMkernel traffic and assign one NI

Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NI

Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel traffic and assign one NI

Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NI

Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMKernel and overlay traffic and assign both NICs.

Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel and overlay traffic and assign a new virtual NI

Launch demo modal

 Loading...

5. What selection is the key design benefit provided by a dedicated Edge Cluster VM or Bare Metal? (Choose the best answer.)

reduced administrative overhead

predictable network performance

multiple Tier-0 gateways per Edge Node Cluster

support for Edge Node Clusters with more than 10 Edge Nodes

Launch demo modal

 Loading...

6. An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

This information was gathered during the Assessment Phase:

- There is a performance based SLA for East C West traffic.

- The business critical applications require prioritization of their traffic.

- One of the services is a file share and has a high demand for bandwidth.

Which selection should the architect include in their design? (Choose the best answer.)

Review average North/South traffic from the core switches and firewall.

Include a segment QoS profile and review the impact of utilizing this feature.

Meet with the organization’s application team to get additional information.

Monitor East-West traffic throughout normal business cycles.

Launch demo modal

 Loading...

7. Which NSX-T feature is used to allocate the network bandwidth to business-critical applications and to resolve situations where several types of traffic compete for common resources? (Choose the best answer.)

Network I/O Control Profiles

LLDP Profile

LAG Uplink Profile

Transport Node Profiles

Launch demo modal

 Loading...

8. An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

This information was gathered during the Assessment Phase:

- Customer currently has a single 10 host vSphere cluster.

- Customer wants to improve network security and automation.

- Current cluster utilization and business policies prevent changing the existing vSphere deployment.

- High-availability is important to the customer.

Which three selections should the architect include in their design? (Choose three.)

Apply vSphere DRS VM-Host anti-affinity rules to the virtual machines of the NSX-T Edge cluster.

Deploy at least two NSX-T Edge virtual machines in the vSphere cluster.

Deploy the NSX Controllers in the management cluster.

Apply vSphere Distributed Resource Scheduler (vSphere DRS) VM-Host anti-affinity rules to NSX Managers.

Remove 2 hosts from the cluster and create a new edge cluster.

Remove vSphere DRS VM-Host affinity rules to the NSX-T Controller VMs.

Launch demo modal

 Loading...

9. An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

This information was gathered by the architect during the Discover Task of the Enagagement Lifecycle:

- There are applications which use IPv6 addressing.

- Network administrators are not familiar with NSX-T Data Center solutions.

- Hosts can only be configured with two physical NICs.

- There is an existing management cluster to deploy the NSX-T components.

- Dynamic routing should be configured between the physical and virtual network.

- There is a storage array available to deploy NSX-T components.

Which constraint was documented by the architect? (Choose the best answer.)

Dynamic routing should be configured between the physical and virtual network.

There are applications which use IPv6 addressing.

Hosts can only be configured with two physical NICs.

There are enough CPU and memory resources in the existing management cluster.

Launch demo modal

 Loading...

10. Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node? (Choose two.)

Reduces storage requirements.

Reduces cost.

Preserves packet locality.

Reduces egress data.

Preserves switchports.

Launch demo modal

 Loading...