Valid H12-821_V1.0 Test Questions Ensure You Pass HCIP-Datacom-Core Technology V1.0 Exam

Regina2021-08-02T06:39:12+00:00

By Regina Free Questions Online, HCIP-Datacom, Huawei H12-821_V1.0, H12-821_V1.0 free questions, H12-821_V1.0 test questions 0 Comments

The Professional level of Huawei Datacom certification requires candidates to pass the written exam, H12-821_V1.0 HCIP-Datacom-Core Technology V1.0 successfully. It is a very important exam which is associate with HCIP-Datacom certification, so we have released valid Huawei H12-821_V1.0 test questions for preparation. Candidates who are planning to take H12-821_V1.0 exam always choose online resource as the study guide. It is highly recommended to use ITExamShop valid H12-821_V1.0 test questions, which will ensure you pass HCIP-Datacom-Core Technology V1.0 H12-821_V1.0 Exam successfully.

We have HCIP-Datacom-Core Technology V1.0 Exam H12-821_V1.0 free questions online for reading.

Page 1 of 2

1. BFD control packets are encapsulated in UDP packets for transmission .

What is the destination port number of multi-hop BFD control packets?

4784

3784

5784

2784

2. In the OSPF protocol, inter-area route calculation involves only Router LSA, Network LSA, and Summary LSA.

TRUE

FLASE

3. Which of the following statements regarding OSPF route summarization is false?

OSPF supports two route summarization modes: ABR summarization and ASBR summarization.

Any router in OSPF can summarize routes.

Route summarization is the process of summarizing routes with the same prefix into one route and then advertising only the summarized route to other areas.

Route summarization can reduce routing information, decrease the routing table size, and improve router performance.

4. As shown in the following figure, a new AP is deployed In dual link MSB networking (load balancing mode) .

Which AC will the connect to?

AC1

Random access

None

AC2

5. Which of the following is the default interval at which the DIS on a broadcast IS_IS network sends CSNPs.

3.3

6. To inject IGP routes into BGP routes, you can only use the network command.

TRUE

FALSE

7. Which of the following statement regarding the display ospf peer command output is true?

Address: 10.1,1.1 Indicates that the local interface address is 10.1.1.1.

Through negotiation during DD packet exchange, the local end becomes the slave.

Router ID indicates that the local router ID Is 10.1.1.1.

The DR address is 10.1.1.1

8. A switch runs MSTP. The configuration is shown in the figure .

What is the role of this switch in MSTI 1?

Uncertain

Root switch

Non-root switch

Secondary root switch

9. The filter-policy 2000 export command is run in an ISIS process .

Which of the following statements about the functions of a filter policy is false?

Is used together with the route import function to advertise some imported external routes to neighbors.

If this command is not run, the device by default advertises all routes that ISIS Imports form external routing protocols.

Controls the advertisement of routes generated by the device.

Filters LSPs to be advertised.

10. To prevent inter-area routing loops, OSPF does not allow advertising routing information between two non-backbone areas and allows sing routing information only within an area or between the backbone area and a non-backbone area. Therefore, each ABR must be connected to the backbone area.

TRUE

FALSE

Page 2 of 2

11. Which of the following statements regarding DR/BDR are false?

In a broadcast network, DR and BDR must be elected. A broadcast network without a DR or BDR cannot operate normally.

DR others listen on the multicast address 224.0.0.5.

All DR others establish neighbor relationships with DR and BDR only.

DR others listen on the network address 224.0.0.6.

12. CORRECT TEXT

There are two BFD operating modes. In_______mode, the local end sends BFD Control packets at specified intervals, and the remote end checks whether the local end periodically sends BFD Control packets. (Use lowercase letters.)

13. Which of the following statements regarding the firewall zone security level is false?

The configured security level cannot be changed.

Two zones cannot be configured with the same security level.

The default security level of the new zone is 1.

Only the security level of the user-defined zone can be configured.

14. Which of the following PIM protocol packets have unicast destination addresses.

Bootstrap

Graft

Assert

15. Which of the following statements regarding the LSA age field are true?

The unit of this field is seconds. In a LSDB, the LS age of a LSA increases with time.

If the LS age of a LSA has reached the LSRefreshTime (30 minutes), any router can regenerate an instance of this LSA again.

The unit of this field is seconds. In a LSDB, the LS age of a LSA decreases with time.

If the LS age of a LSA has reached the LSRefreshTime (30 minutes), the originator of this LSA needs to regenerate an instance of this LSA again.

Welcome To Choose Required IT Certification Exams Online

Valid H12-821_V1.0 Test Questions Ensure You Pass HCIP-Datacom-Core Technology V1.0 Exam

We have HCIP-Datacom-Core Technology V1.0 Exam H12-821_V1.0 free questions online for reading.

Author

Leave a Reply Cancel reply