Learn and Prepare For HPE6-A72 Exam With Real HPE6-A72 Practice Test

Learn and Prepare For HPE6-A72 Exam With Real HPE6-A72 Practice Test

Learn HPE6-A72 Aruba Certified Switching Associate Exam by yourselves and prepare for HPE6-A72 exam with real HPE6-A72 practice test now. We have HPE Certification HPE6-A72 practice test with 88 questions and answers, covering the fundamental skills necessary to configure and manage modern, open standards-based networking solutions using Aruba’s OS-CX routing and switching technologies in small to medium enterprise network solutions. It is a great way to get success in actual HPE6-A72 exam, just choose to learn HPE6-A72 exam in a short time by reading actual and real HPE6-A72 practice questions at ITExamShop.

Read Below HPE6-A72 Free Questions To Make Sure ITExamShop HPE6-A72 Practice Test Are Perfect

Page 1 of 3

1. Refer to the exhibit.





You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.

What is a valid configuration for Access-2 to join the VSF stack?

2. What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)

3. Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?

4. Refer to the exhibit.





Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.

Which configuration will correct the issue?

5. DRAG DROP

Match the term to the correct description.



6. What is Deep Packet Inspection?

7. What is the binary conversion of the hexadecimal value 0x2001?

8. You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

9. The following command is issued:

Switch# checkpoint rollback start

What is the result?

10. Refer to the exhibit.





The above output is the result of issuing the command show system resource-utilization.

What command should be used to enable terminal output line by line or page by page?


 

Leave a Reply

Your email address will not be published.