CCNP Collaboration Concertration Exam 300-815 CLACCM Practice Test

Regina2021-08-18T06:25:50+00:00

By Regina CCNP Collaboration, Cisco, Free Questions Online 300-815, 300-815 free questions, 300-815 practice test 0 Comments

Every candidate knows that earning CCNP Collaboration certification needs to complete the core exam 350-801 CLCOR and one of the concertration exams. As one of the concertration exams, 300-815 CLACCM Implementing Cisco Advanced Call Control and Mobility Services main tests your skills in Signaling and media protocols, CME/SRST gateway technologies, Cisco Unified Board Element, Call control and dial planning, Cisco Unified CM Call Control and Mobility. Cisco 300-815 practice test have been created by the top team, they collected 86 practice exam questions and answers to ensure that you can complete the CLACCM 300-815 exam smoothly.

First come to read Cisco CCNP Collaboration 300-815 CLACCM Free Questions.

Page 1 of 2

1. What is first preference condition matched in a SIP-enabled incoming dial peer?

incoming uri

target carrier-id

answer-address

incoming called-number

2. Refer to the exhibit.

Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms.

What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?

calling number 613-555-1234 and numbering type “subscriber”

calling number 011-1-613-555-1234 and numbering type “subscriber”

calling number 011613-555-1234 and numbering type “international”

calling number 613-555-1234 and numbering type “national”

3. In Cisco Unified Communications Manager globalized call routing is implemented and must confirm that it is correctly implemented without making a call.

Which tool do you use for verification?

Dialed Number Analyzer

Real-Time Monitoring Tool

SDI trace

SDL trace

4. Which services are needed to successfully implement Cisco Extension Mobility in a standalone Cisco Unified Communications Manager server?

Cisco Extended Functions, Cisco Extension Mobility, and Cisco AXL Web Service

Cisco CallManager, Cisco TFTP, and Cisco CallManager SNMP Service

Cisco CallManager, Cisco TFTP, and Cisco Extension Mobility

Cisco TAPS Service, Cisco TFTP, and Cisco Extension Mobility

5. Refer to the exhibit.

The Cisco Unified Border Element receives an INVITE matching inbound dial peer 5002. The outbound dial peer supports only iLBC. and a Local Transcoding Interface is allocated.

Based on the configuration and SDP from the INVITE message, which codec is chosen by Cisco Unified Border Element for the inbound call leg?

711 A-law

711 U-law

729r8

729br8

6. Refer to the exhibit.

A user reports that when they call a specific phone number, no one answers the call, but when they call from a mobile phone, the call is answered. The engineer troubleshooting the issue is expecting the far-end gateway to cut through audio on the 183 Session Progress SIP message.

Which SIP Profile configuration element is necessary for the Cisco Unified Communications Manager to send acknowledgement of provisional responses?

Allow Passthrough of Configured Line Device Caller Information must be enabled.

Accept Audio Codec Preferences in Received Offer must be set to On.

On the SIP Profile, the configuration parameter SIP Rel1XX Options must be set to Send PRACK for all 1xx Messages.

Early Offer for G Clear Calls must be enabled.

7. Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?

Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.

Configure IP Address Trusted Authentication for Incoming VoIP Calls.

Configure the command no ip address trusted authenticate under “voice service voip”.

Enable Secondary Dial tone on Analog and Digital FXO Ports.

8. Which configuration element of a hunt group allows for changing Calling Party Transformations settings?

line group

hunt pilot

route group

hunt list

9. Refer to the exhibit.

Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator.

Which action resolves this issue?

Adjust the service parameter T302 timet to the desired value.

Adjust the service parameter T204 timer to the desired value.

Check the Urgent Priority check box under 9.911 pattern.

Point the emergency pattern directly to the PSTN gateway.

10. The Cisco Unified Communications Manager Dialed Number Analyzer allows analysis of calls from which two devices? (Choose two.)

translation patterns

device pools

CTI ports

CTI route points

IP phones

Page 2 of 2

11. An administrator is troubleshooting call failures on an H.323 gateway via the CLI.

To see signaling for media and call setup, which debug must the Administrator turn on?

debug

323 messages

debug

225 asn1

debug

246 asn 1

debug

225 media

debug

323 asn 1

12. What is a component of Cisco Unified Mobility?

Unified IVR

Mobile Connect

Smart Client Support

Single Number Connect

13. An engineer is configuring a call park feature in Cisco Unified Communications Manager Express.

Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?

R2(config-ephone-dn)#park reservation-group 60

R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002

R2(config-ephone-dn)#park reservation-group 1

R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002

14. Refer to the exhibit.

In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.

Which two scenarios are correct? (Choose two.)

Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.

Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.

As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.

As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.

As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.

15. Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?

Analysis Manager > Inventory > Trace File Repositories

System > Tools > Trace and Log Central

Voice/Video > Session Trace Log View > Real Time Data

Voice/Video > Session Trace Log View > Open From Local Disk

16. Refer to the exhibit.

DN 1003 was the last to ring during the most recent call.

Which hunting method ensures that DN 1005 is presented with the next call when the hunt pilot is dialed?

call-blast

parallel

sequential

peer

17. Refer to the exhibit.

An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction.

What must be configured in the dial peer 1 to fix the issue?

answer-address 555 ……..

codec g729

session-protocol sipv2

incoming called number 555…….

18. Refer to the exhibit.

An engineer is troubleshooting an issue where inbound calls to Cisco UCM with early media fail to establish. While investigating the issue, the engineer finds that Cisco UCM is set to require a PRACK. but the Cisco Unified Border Element is not sending it.

Which command is causing this issue?

voice-class sip rel1xx disable

voice-class sip early-media update block

voice-class midcall-signaling block

voice-class sip conn-reuse

19. Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?

System > Location Info

Call Routing > Route/Hunt > Local Route Group Names

System > Device Pool

Call Routing > Emergency Location > Emergency Location (ELIN) Groups

20. Refer to the exhibit.

An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu.

Which two steps must be performed to resolve this issue? (Choose two.)

Restart the subscriber

Activate the Cisco Extended Functions service.

Activate the Cisco Call Manager service.

Activate the Cisco Dialed Number Analyzer service.

Activate the Cisco Dialed Number Analyzer Server service.

Welcome To Choose Required IT Certification Exams Online

CCNP Collaboration Concertration Exam 300-815 CLACCM Practice Test

First come to read Cisco CCNP Collaboration 300-815 CLACCM Free Questions.

Author

Leave a Reply Cancel reply